| Color |
Gray
Scope
Material KB-Flex 200 is used for waterproofing of tubes and pipes in the buildings under the ground. Used for sealing leaks, and pipes, which water flow takes place under strong pressure. Used on surfaces: concrete, stone, limestone, plaster and ceramic, polyvinyl, polyethylene, polypropylene cover.
Surface preparation
surface may be dry, moist or wet. Must be cleaned of grease, lubricants and resins.
pipeline must be completely cleaned from the inside, to avoid dust, dirt, sediment, sand and other small debris.
Application
Before use, the contents of the cartridge KB-Flex 200 down into the warm water and heated to a temperature of approximately 30 o C, which gives the best consistency of the material to be used. Waterproofing layer is made using the KB-Flex 200 must meet certain size. Proportionality material length to diameter (maximum 300 mm) shall conform to not less than 1.5 to 1.
Before using the KB-Flex 200 brick, stone, or any other limit to be placed at a depth of 10 cm in the whole pipeline exception overexpenditures material. Cartridge KB-Flex 200 is installed in the gun and the material is extruded into pipe, rear to front using a nozzle (orifice) so that the resulting coating thickness was not less than 8 cm
After sealing of the cable need to shatter the pipeline and cable space, which is formed, filled pasta KB-Flex 200. After sealing the need to make sure that the cable is not stretched. And, finally, sealing the mixture to impose a layer of 1 cm, well push and align the metal spatula. To further guarantee the inlet pipe is covered KӦSTER KB-FIX 5.
In the subsequent installation of new cables, you must first dismantle KӦSTER KB-FIX 5, after which the new cable is pushed out through the KB-Flex 200. If necessary, re-sealed pipe indentation KB-Flex 200.
|