dry mixture at Portland, silica filler and additives to hold water in the process of hardening, improve water penetration and accelerate setting.
Scope

applied to damp surfaces. Do not apply in cases where there are constant hydrostatic pressure of the water.
Advantages material

    * single composition.
    * used on both concrete and brick base.
    * Easy to use - requires no special equipment.
      Instructions for use

      Surface preparation

          base should be clean and obespylennym. Dust and oil stains, paints, etc. weakened adhesion obmazochnoy waterproofing to the base.

          Preparation of solutions

              Obmazochnaya waterproofing is mixed with clean water in a ratio of 230 grams of water per kilogram of dry mixture. For mixing used to drill nozzle. The solution must withstand 10 minutes to dissolve additives, then mix.

              Surface

                  thickness obmazochnoy waterproofing 2-3 mm. Waterproofing sprayed Obmazochnaya brush or roller to the pre-treated surface. You may use as a wet or dry ground. Not applicable to address active leaks, as well as in cases where there is a constant hydrostatic pressure of the water. Strength Waterproofing cover increased by inflicting a second layer. In this case, after drawing the first layer must take at least 24 hours. The composition can be used for injection of cracks and joints in the panels, as a solution to repair major defects. In this case, the dry mixture can be added up to 10% by weight of a larger silica filler (~ 1 mm).
                  Specifications L AHTY OBMAZOCHNOY

• characteristics of the material	Value
  Mobility mixture	Pk = 4
  Compression strength	40 MPa
  bending strength	9,2 MPa
  Adhesion	1,5 MPa
  Vodouderzhivayuschaya ability	98%
  The cost of 1 mm thickness	1,5 kg / m 2
  to make waterproof	W 12

Find "Lahti obmazochnaya waterproofing" in the directory of organizations