dry mixture at Portland, silica filler and additives to hold water in the process of hardening, improve water penetration and accelerate setting. characteristics of the material
applied to damp surfaces. Do not apply in cases where there are constant hydrostatic pressure of the water.
* single composition.
* used on both concrete and brick base.
* Easy to use - requires no special equipment.
Instructions for use
base should be clean and obespylennym. Dust and oil stains, paints, etc. weakened adhesion obmazochnoy waterproofing to the base.
Preparation of solutions
Obmazochnaya waterproofing is mixed with clean water in a ratio of 230 grams of water per kilogram of dry mixture. For mixing used to drill nozzle. The solution must withstand 10 minutes to dissolve additives, then mix.
thickness obmazochnoy waterproofing 2-3 mm. Waterproofing sprayed Obmazochnaya brush or roller to the pre-treated surface. You may use as a wet or dry ground. Not applicable to address active leaks, as well as in cases where there is a constant hydrostatic pressure of the water. Strength Waterproofing cover increased by inflicting a second layer. In this case, after drawing the first layer must take at least 24 hours. The composition can be used for injection of cracks and joints in the panels, as a solution to repair major defects. In this case, the dry mixture can be added up to 10% by weight of a larger silica filler (~ 1 mm).
Specifications L AHTY OBMAZOCHNOY
Pk = 4
The cost of 1 mm thickness
1,5 kg / m 2
to make waterproof
dry mixture at Portland, silica filler and additives to hold water in the process of hardening, improve water penetration and accelerate setting.
characteristics of the material